First, apply a layer of transparent polish on your nail surface and the inside of the patch (so you only need to use nail polish remover when removing the nail, and it can protect your nails and make the patch last longer!) Then squeeze one or two drops of professional glue on the back of the nail piece, turn it slightly to make the glue distribution more evenly, and then make the nail piece and the nail at a 45-degree angle, align the rear edge of the false nail with the rear edge of your nail, and then slowly Press firmly to the front. Pay special attention to post it once.1. It is recommended to drip glue on your nails, not on the back of false nails. Because when we bring it, we have to hold the nail piece and stick it on the real nail. If it is applied to the back of the nail piece, even if it is careful, it will easily get the glue on the hand.2. Prepare toothpicks and facial tissues before bringing them together. Toothpicks can help you spread out the glue dripping on your nails. The advantage is to avoid pouring too much glue at once. If there is too much glue, just use facial tissue to absorb some.The amount of glue can be controlled according to the length of wearing time.If you wear it for a long time, just apply glue to the nail surface and keep it for a month. (For longer, you can use sand bars to polish the surface of the real nail a little rougher, which is good for the adhesion of the glue and can be maintained for a longer time!)For short-term wear, you can apply less glue on the root of the nail (you can apply the glue first, and then use facial tissue to suck off the root). This method can last for about one day, and it is relatively strong when it is worn on the same day (it is much easier to use and more practical than double-sided tape), and it is easier to go home at night or take it off the next day.If it is a temporary wear, use a toothpick to apply glue to the edge of the nail, so that the middle is hollow, and it is easy to drop. This method is suitable for temporary wear.

1. Elija la pieza de las uñas con el mismo tamaño que el clavo (Si hay un tamaño diferente, elija el más similar y recorte TI). 2. Remoje las manos con agua tibia, aplique el fluido suavizante al área de la piel muerta en los bordes de los dedos, empuje la piel muerta con un empujador de la piel muerta, y corte la piel muerta con piel muerta especial. 3. Use un archivo para tallar y pulir las uñas y pulir el clavo Superficie. 4. Aplique pegamento a la pieza de uñas recortada, presione y empuje con la punta de los dedos (así que, la pieza de uñas puede estar estrechamente unida a la uña) 5. Corte a la longitud que cree que es adecuado, y comience a pulir el medio pegado Lugar, principalmente para recortar el grosor. Después de recortar, no mires con el ojo desnudo, sino que use el dedo para sentir. Si Se siente plano, se recorta, y luego la forma de la uña está recortada. (Si tiene las condiciones, se recomienda que no necesite pulir el área medio pegado después de aplicar el clavo falso, primero recorte la forma de la uña, y luego aplique el material de las uñas de cristal, que es el medio palo de cristal, que es más conveniente).